GY521 MPU6050 Module 3 Axis Gyroscope Accelerometer Module IN PAKISTAN

(1 customer review)




GY521 MPU6050 Gyroscope Accelerometer Module 3 Axis Gyroscope  Module IN PAKISTAN


The InvenSense MPU-6050 sensor contains a MEMS accelerometer and a MEMS gyro in a single chip. It is very accurate, as it contains 16-bits analog to digital conversion hardware for each channel. Therefor it captures the x, y, and z channel at the same time. The sensor uses the I2C-bus to interface with the Arduino.

The MPU-6050 is not expensive, especially given the fact that it combines both an accelerometer and a gyro.


  • I2C Digital-output of 6 or 9-axis Motion Fusion data in rotation matrix, quaternion, Euler Angle, or raw data format
  • Input Voltage: 2.3 – 3.4V
  • Selectable Solder Jumpers on CLK, FSYNC and AD0
  • Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000dps
  • Tri-Axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g
  • Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronization and gesture detection
  • Embedded algorithms for run-time bias and compass calibration. No user intervention required
  • Digital-output temperature sensor

Image result for mpu6050 arduino

Package Includes GY521 MPU6050 Gyroscope Accelerometer:

1 x GY521 MPU6050 Module 3 Axis Gyroscope Accelerometer Module

  • Model NO.:     GY-521 MPU-6050  Module
  • Chip: MPU-6050
  • Power supply : 3-5v (internal low dropout regulator)
  • Communication modes: Standard IIC communications protocol Chip
  • Built-in 16bit AD converter, 16-bit data output
  • Gyroscope range:  250 500 1000 2000 ° / s
  • Acceleration range:   2   4   8  16g
  • Immersion Gold PCB machine welding process to ensure quality
  • Pin pitch: 2.54mm


1 review for GY521 MPU6050 Module 3 Axis Gyroscope Accelerometer Module IN PAKISTAN

  1. Muhammad Ahmad

    Muhammad A. (verified owner)

Add a review

Your email address will not be published. Required fields are marked *