EDGE 540 FPV Aerobatic RC plane Depron Kit




Edge 540 FPV Plane Kit is based on the which is a great aerobatic plane and also a very popular choice for pilots competing in the Red Bull Air Races.

The Edge 540 captures the crisp lines of the real Edge while offering a wide flight envelope capable of doing anything from smooth pattern flying to extreme aerobatic maneuvers. Appealing to both sport fliers and 3D pilots alike.

Edge 540 FPV Plane Kit has a removable one-piece wing so that it can be easily transported even in smaller vehicles.  it’s large hatch allows easy access to the battery and other electronics. It also has optional landing gear, wheel pants and side force generators allowing you to customize the aircraft to your own preferences.
This plane was designed to suit my personal preferences as a pilot, so the design has been optimized for 3D aerobatics with large control surfaces enabling the plane to do anything you can throw at it. It has a good power-to-weight ratio when paired with our Power Pack C motor. This delivers enough power for unlimited vertical while keeping the aircraft light enough for low and slow aerobatics.
These characteristics make this plane suitable for seasoned 3D pilots as well as those just getting into aerobatic flying. No matter where you are in your journey through the world of flight the Edge 540 can serve as a platform for you to further your flying experiences

• Wingspan: 40 inches (1016mm)
• Weight: 680g (23.98oz)
• COG: 3.25 inches (83mm) from leading edge
• Control Throws: 16 Degrees+
• Expo: 30% (recommended)


Required but not included:

● Brushless motor: 1400kv
● Propeller: 9×3.8 SF or 9×4.7 SF or 8045
● Electronic Speed controller (ESC):any 30amp
● 4 nos: Servos: sg90 or mg90
●  2.4GHz transmitter and receiver
● Lipo battery: 1500 or 2800 mah 3S
● Charger: imax B3AC charge

6040E High Speed Propeller Efficient Resistance For RC Plane


There are no reviews yet.

Be the first to review “EDGE 540 FPV Aerobatic RC plane Depron Kit”

Your email address will not be published. Required fields are marked *