DIY Stun Gun Module High Voltage Generator


2 in stock


DIY Stun Gun Module MC105 Pulse DC 3.6V-6V 400KV Boost Step Up Power Module High Voltage Generator Transformer High Voltage Converter uses the principle Tesla coil is made of high-voltage pulse output voltage. current, small size , high efficiency, simple external circuit ( just plug in the switch , the battery can be )

discharge intensity violent.

Specifications of DIY Stun Gun Module:

  • Voltage: Input DC3.6-6V, output DC400kV – 600KV( Please pay attention to safety when used )
  • High Type : Pulse Current
  • High voltage bipolar discharge distance : 10mm-20mm
  • Output voltage lines Length: about 100mm
  • Input power cable length: about 10mm ( red is positive )
  • Dimensions : Φ24 * 63mm

Input power:

  • 3.7V Li-ion battery can be used 1 or 2 section , such as 18650 , idle cell phone batteries ( to remove the for protection board , Recommended capacity of 2000mAh or more ) or NiCd / NiMH battery pack , 4V or 6V Lead Acid batteries.
  • This module is a small production with high-pressure science inverter transformer / booster finished module, the input terminal DC3V-7.2V voltage can get 200,000 volts for DC high voltage ( about 1-2cm arc ) at the output can be used as high school science experiments , electronic equipment, negative ion generator, high voltage source to use when making small science .


  • To avoid high-pressure high-voltage module load electricity use . Must adjust the high voltage side suitable distance(before electricity, battery voltage and capacity is proportional to the distance from high-voltage arcing used when testing the arc distance from short to long experiment , prohibited from beyond the arc when powered up , the energy can not be released due to high pressure , easily damage the module.)

DIY Stun Gun Module High Voltage Generator


There are no reviews yet.

Be the first to review “DIY Stun Gun Module High Voltage Generator”

Your email address will not be published. Required fields are marked *