Line Follower Robot using Arduino UNO

Components Details

Arduino UNO, ROBOT 3 WHEELS VEHICLE CHASSIS, IR Sensor x 3, male to female jumper wires, female DC pin, 4007 Diode, 1k resistor , LED, L298 Motor Driver, Switch On/Off, Battery 8.2v

Here is a very simple and easy robot. In this project, I will explain how to design and build a Line Follower Robot using microcontroller. The Line Follower Robot is a basic robot that follows a specific path indicated by a line (usually a black line on a light colored surface) having some particular width.

Working:

Working of line follower is very interesting. Line follower robot senses black line by using sensor and then sends the signal to arduino. Then arduino drives the motor according to sensors’ output.

Here in this project we are using two IR sensor modules namely left sensor and right sensor. When both left and right sensor senses white then robot move forward.

If left sensor comes on black line then robot turn left side.

If right sensor sense black line then robot turn right side until both sensor comes at white surface. When white surface comes robot starts moving on forward again.

If both sensors comes on black line, robot stops.

*******BUY*******

Customizable Self Balancing Arduino Robot